Регулятор RCX 20A ESC Brushless Motor Speed Controller (G Series / Programed for Multicopter - SimonK Firmware)

Programmable Features:
Brake Setting：Enabled / Disabled, default is Disabled
Battery Type：Li-xx(Li-ion or Li-poly) / Ni-xx(NiMH or NiCd)，default is Li-xx.
Low Voltage Protection Mode(Cut-Off Mode)： Soft Cut-Off (Gradually reduce the output power) or Cut-Off (Immediately stop the output power).

Default is Soft Cut-Off.                                                           
Low Voltage Protection Threshold(Cut-Off Threshold)：Low / Medium / High, default is Medium.
For lithium batteries, the number of battery cells is calculated automatically.

Low / medium / high cutoff voltage for each cell is: 2.6V/2.85V/3.1V.

For example: For a 3 cells lithium pack, when “Medium” cutoff threshold is set, the cut-off voltage will be: 2.85*3=8.55V.
For nickel batteries, low / medium / high cutoff voltages are 0%/45%/60% of the startup voltage (i.e. the initial voltage of battery pack), and 0% means the low voltage cut-off function is disabled. For example: For a 10 cells NiMH battery, fully charged voltage is 1.44*6=8.64V, when “Medium” cut-off threshold is set, the cut-off voltage will be:8.64*50%=4.3V。
Startup Mode：Normal /Soft /Super-Soft, default is Normal.
Normal is preferred for fixed-wing aircraft. Soft or Super-soft are preferred for helicopters.

The initial acceleration of the Soft and Super-Soft modes are slower in comparison, usually taking 1 second for Soft startup or 2 seconds for Super-Soft startup from initial throttle advance to full throttle. If the throttle is closed (throttle stick moved to bottom) and opened again (throttle stick moved to top) within 3 seconds of the initial startup, the restart-up will be temporarily changed to normal mode to get rid of the chances of a crash caused by slow throttle response. This special design is very suitable for aerobatic flight when quick throttle response is needed.
Timing：Low / Medium / High, default is Low.
Usually, low timing value can be used for most motors. We recommend the Low timing value for 2 poles motor and Medium timing value for motors with more than 6 poles to get a high efficiency. For higher speed, High timing value can be chosen.
You can't use the programming card on SimonK Firmware ESC since the original program was replaced. Above features are no longer an option.

Характеристики:
Continuous Current: 20A
Burst Current: 25A
Input Voltage: Lipo 2-4 Cells
Input Voltage: NiMH NiCd 6-16.8V
BEC: 5V  2A
Size:  36mm (L) * 26mm (W) * 7mm (H)
AWG Cable: 16#
Weight: 22g

Designed for
Multicopter.