Гоночная рама с PDB Cross Racing Quadcopter With 4mm Arms for QAV-X 210 Pure Carbon Fiber

The bottom fuselage uses 4MM pure carbon fiber board, fuselage and arms in one make the space bigger and make it stronger.

Only 100g, and stable.

With 5V 12V distribution board, compatible with 3S and 4S battery

With 5 inch flat blade, more efficient than the other propeller.

In high strength test, flying fluently in cornering, is suitable for the competition

Характеристики рамы:

Item Name: QAV-X Carbon Fiber Frame Kit

Material: Carbon Fiber

Wheelbase: 214mm

Floor: 4mm

On board: 1.5mm

Net Weight: about 95g (airframe 89g with battery protector plate 6g).

Matek PDB-XT60 distribution board:

The PDB-XT60 has been engineered to provide the highest possible performance and reliability in a 36*50mm & 4 layers PCB. It distributes power from a LiPo pack to 6 ESCs, as well as providing synchronised & regulated DC 5V outputs & linear regulated DC 12V for powering Cameras, Servos, RC receiver, Flight Controllers, Video Transmitters, LEDs, etc.

It offers a XT60 socket to connect the LiPo pack conveniently.

Характеристики PDP:

General:

-Input voltage range (3S-4S LiPo operation): 9 - 18V DC

-Regulated 5V and 12V outputs

-LED power indicators ( 5V & 12V outputs )

-6 ESC outputs & 1 pair VCC/GND pads

ESC outputs:

-Continuous current: 25A*4 or 15A*6

-Peak current (10 seconds/minute): 30A*4 or 20A*6

BEC 5V output:

-Designed for RC Receivers, Flight controllers, OSD, and Servos.

-DC/DC synchronous buck regulator.

-Voltage: 5.0 +/- 0.1VDC

-Continuous current: 2 Amps (Max.2.5A 10s/minute)

-Output Ripple: 40mV (VIn=16V, VOut=5V@2A load)

-Short-circuit tolerant (5 seconds/minute)

BEC 12V output:

-Designed for Video TX or FPV camera with linear regulator.

-The battery should be 4S LiPo (13~18V DC)

- Voltage: 12.0 +/- 0.3VDC

-Continuous current: 500mA (Max.0.8A 5s/minute)

-Short-circuit tolerant (2 seconds/minute)

BEC 12V @ 3S LiPo

-Output voltage= 3S LiPo voltage -1V

Physical:

-Dimensions: 36 x 50 x 4 mm (without XT60)

-Mounting: 30.5 x 30.5mm, Φ3mm

- Weight: 7.5g(w/o XT60), 11g(w/ XT60)

Features:

2oz copper, 4-layers &1.6mm PCB.

Built-in XT60 Socket

Total 6 pairs ESC solder tabs are fit for H or X type frame 5V & 12V Output LED indicators & Short circuit tolerant

Комплект:

1 x the QAV-X quadcopter frame set (unassembled)

1 x battery belt

1 x Matek PDB board