Полетный контроллер + регулятор SPEEDYBEE APP STACK F7 F722 V3 Flight Control 50A ESC World's first wireless firmware flasher and blackbox analyzer for iflight

Полетный контроллер + регулятор SPEEDYBEE APP STACK F7 F722 V3 Flight Control 50A ESC World's first wireless firmware flasher and blackbox analyzer for iflight

Описание:

Контроллер

Product Name

SpeedyBee F7 V3 Flight Controller

MCU

STM32F722

IMU(Gyro)

BMI270

USB Port Type

Type-C

Barometer

BMP280

OSD Chip

AT7456E chip

BLE Bluetooth

Supported. Used for Flight Controller configuration

Flash FC Firmware Wirelessly

Supported. Please enter MENU > FC Firmware Flasher

Download/Analyze Blackbox

Supported.Please enter MENU > Blackbox Analyzer

DJI Air Unit Connection Way

Two ways supported: 6-pin connector or direct soldering.

Flash(for BlackBox)

500MB

BetaFlight Camera Control Pad

Yes(CC pad on the front side)

Power Input

3S - 6S Lipo

5V Output

10 groups of 5V output, three +5V pads and 1 BZ+ pad( used for Buzzer) on front side, and 6 +5V output included in the connectors on bottom side. The total current load is 2A.

9V Output

2 groups of 9V output, one +9V pad on front side and other included in a connector on bottom side. The total current load is 4A.

3.3V Output

Supported. Designed for 3.3V-input receivers. Up to 500mA current load.

4.5V Output

Supported. Designed for receiver and GPS module even when the FC is powered through the USB port. Up to 1A current load.

ESC Signal Pads

M1 - M4 on bottom side and M5-M8 on front side.

UART

5 sets(UART1, UART2, UART3, UART4(For ESC Telemetry), UART6)

ESC Telemetry UART

R4(UART4)

I2C

Supported. SDA & SCL pads on front side. Used for magnetometer, sonar, etc.

LED Pad

Used for WS2812 LED controlled by Betaflight firmware.

Buzzer

BZ+ and BZ- pad used for 5V Buzzer

BOOT Button

Supported.

[A]. Press and hold BOOT button and power the FC on at the same time will force the FC to enter DFU mode, this is for firmware flashing when the FC gets bricked.

[B]. When the FC is powered on and in standby mode, the BOOT button can be used to controller the LED strips connected to LED1-LED4 connectors on the bottom side. By default, short-press the BOOT button to cycle the LED displaying mode. Long-press the BOOT button to switch between SpeedyBee-LED mode and BF-LED mode. Under BF-LED mode, all the LED1-LED4 strips will be controlled by Betaflight firmware.

RSSI Input

Supported. Named as RS on the front side.

SmartPort

Use any TX pad of UART for the SmartPort feature.

Supported Flight Controller Firmware

BetaFlight(Default), EMUFlight, INAV

Firmware Target Name

SPEEDYBEEF7V3

Mounting

30.5 x 30.5mm( 4mm hole diameter)

Dimension

41(L) x 38(W) x 8.1(H)mm

Weight

10.7g

Регулятор

Product Name

SpeedyBee BL32 50A 4-in-1 ESC

Firmware

SpeedyBee BL32 50A